Lotos LTP7000 Guida di Installazione

LOTOS LTP7000 Plasma Cutter

9 1. Direct interference radiated from the plasma cutter. 2. Direct interference radiated from the plasma cutting leads. 3. Direct interference

10 ! INPUT CONNECTIONS ELECTRIC SHOCK can be fatal % Have a qualified electrician install and service this equipment. % Turn the input power

11 ! OUTPUT CONNECTIONS ELECTRIC SHOCK can be fatal % Keep the plasma cutting torch and ground cable & clamp in good condition and in safe

12 " OUTPUT AND GAS CONNECTION FOR PLASMA CUTTING (Figure A.3) The plasma cutting torch and ground cable are supplied with the

13 OPERATION PLEASE READ AND UNDERSTAND THIS ENTIRE SECITON BEFORE OPERATING YOUR MACHINE. ONLY QUILIFIED PERSONNEL SHOULD OPERATE T

14 MAINTENANCE PLEASE READ AND UNDERSTAND THIS ENTIRE SECTION BEFORE DOING MAINTENANCE FOR YOUR MACHINE. ONLY QUALIFIED PERSONNEL SH

15 TROUBLESHOOTING PLEASE READ AND UNDERSTAND THIS ENTIRE SECTION. SERVICE AND REPAIR SHOULD ONLY BE PERFORMED BY TRAINED PERSONNEL FOR YO

16 ! PROBLEMS IN PLASMA CUTTING TROUBLESHOOTING PLASMA CUTTING PROBLEMS (SYMPTOMS) PROBLEM CAUSE RECOMMENDED ACTION Fan stops working % Fan pow

17 OTHER ACCESSORIES The following accessories and consumables can be purchased on www.uwelding.com, or call 408-739-2329 to order. C

1 ! TABLE OF CONTENTS SAFETY ...

2 SAFETY PLEASE READ AND UNDERSTAND THE FOLLOWING SAFETY HIGHLIGHTS. BE SURE THAT ALL INSTALLATION, OPERATION, MAINTENANCE AND REPAIR PROCEDURES A

3 and that of your helpers from the arc rays. " Protect other nearby personnel with suitable, non-flammable screening and/or warn them not t

4 # Away from areas where they may be struck or subjected to physical damage. # A safe distance from arc welding or cutting operations and any ot

5 SPECIFICATIONS ! GENERAL DESCRIPTION The LOTOS LTP7000 IGBT Plasma Cutter is one of the most powerful inverter plasma cutters in the market. T

6 ! POWER SUPPLY RATINGS LTP7000 General Specification Input Voltage 220~240V10%, 1-PH, 50/60Hz Input Current 30A No-load Voltage 230V Working En

7 ! REAR CONTROL PANEL The unit is connected to the supply even if the Power Switch is in the “OFF” position, and therefore there

8 INSTALLATION PLEASE READ ENTIRE INSTALLATION SECTION BEFORE STARTING INSTALLATION. BE SURE THAT ONLY QUALIFIED PERSONNEL SHOULD PERFORM THI